Capvern les Bains, 65130. The end wall of the old Salon de thé fell away. It had a tarp covering the roof for quite some time.
![]() |
The odd, unrelated events in life, living in the Baronnies, in the south of France
I've seen a rat around the outside of the house, and on the shed roof, but it then disappeared. Turns out they have strong enough claws to walk on walls.
Bought this a good few years ago when Leclerc had it on offer.
Rip out all the screws on this side. You can leave the black cover in place.
Carefully remove the screw under the rear sticker about half way. Balance it on securely on some wood chocks. Working from the front, it should just come off. If not keep undoing the rear screw a turn at a time.
With it now open, keep pressure on the black cable reel. Turn the case, ACW holding the reel a until the cable block gets to the case, then add a couple of turns. Reassemble.
It wont matter if the black reel does come away - the spring will just pop out quite safely. But now you'll need to rewind it all. It can be tricky holding the tensioned reel in place and refitting the top. In that case remove the black cover and small centre screw. Then feed the cables through, place the slip ring north/south and refit the cover, passing the cables back through and matching up the square peg of the slip rings.
After over 20 years of riding, we sold the bikes. It's not that we'll stop riding, it's just that we've barely ridden them in 2 years. Too hot, too cold, too many other things to do that we are enjoying more.
Received the money 27/4/26
Last seen at the dealer 😘
I have a JVC cross media system that I bought in the mid 80s. It's slowly less relevant, and being old-school there is no remote! I started modifying the tuner to control the rest, but most radio stations are now streamed....
Found an old satellite TV STB and gutted it. A good compact size.
Before (mains lead removed)
How to remove the paddle/aerator on a Bosch series 4 washing machine.
There are lots of videos, but none show where the clip is. It's probably the same paddle design on a lot of these Bosch machines.
You can see the tab that needs lifting towards the bottom of the left photo. In the other photo, insert the screwdriver through the hole, under the tab arm and push down towards the drum. You're aiming to lift the arm. Not too much. Then slide the paddle towards the front.
The access below the paddle is just enough to get a small pair of pliers through to the outer, and pick out bits of wire etc. Otherwise you'll need to pull the heating element.