Bought this a good few years ago when Leclerc had it on offer.
Good enough, but recently it's not been winding back the last metre.
Rip out all the screws on this side. You can leave the black cover in place.
Carefully remove the screw under the rear sticker about half way. Balance it on securely on some wood chocks. Working from the front, it should just come off. If not keep undoing the rear screw a turn at a time.
With it now open, keep pressure on the black cable reel. Turn the case, ACW holding the reel a until the cable block gets to the case, then add a couple of turns. Reassemble.
It wont matter if the black reel does come away - the spring will just pop out quite safely. But now you'll need to rewind it all. It can be tricky holding the tensioned reel in place and refitting the top. In that case remove the black cover and small centre screw. Then feed the cables through, place the slip ring north/south and refit the cover, passing the cables back through and matching up the square peg of the slip rings.
No comments:
Post a Comment